I have a desktop at home that connects to a router, I had set up ssh port forwarding, allowed firewall access on the corresponding port and changed ssh config to listen to the specific port. It was all working correctly, I could ssh to my desktop remotely (from workplace). But recently we switched our internet provider, so brand new router etc, I went on to do all the same thing I had done before, but now seems like I cannot access to my desktop from remote computers (even with a laptop on the same local wireless network).
So both on the remote computer or a laptop in the same local wireless network, I would get the Connection timed out error, and if I ping my router's public ip adress, it shows 0 received: 50 packets transmitted, 0 received, 100% packet loss, time 50032ms. Site like CanYouSeeMe.org shows that it can see my port.
Any suggestions? Thanks
Edit:
So from the related post below, someone suggested that
Some ISPs use a system called CG-NAT to use one IP address for multiple connections, due to the global shortage of IPv4 addresses. This would prevent any incoming connections, and is typically used only on entry-level plans.
I wonder could this be true? How could this prevent any incoming connections, for example, the browser is sending request outward and getting result back all the time.
There is a related issue Bell Home Hub 2000 Port Forwarding.
Update:
As suggested by davidbaumann in the comment section, I tried to access to the host on an external network just to make sure (I tried a while ago and it didn't work, so I have been testing access just from my local network), and it logged it, even though ssh username@host_public_ip_adress -p external_port still does not work in a local network, can someone explain?
